12450 Whittier Blvd, Whittier, CA 90602 Tel: (562) 907-2600 FAX: (562) 907-2606 www.riveraprimoinc.com BRUTE FORCEBRUTE FORCETMTMBelt DriveIN
IMPORTANT !** Prior to starting this installation, disconnect and remove the battery. Secure the motorcycle so it will not fall and so youhave complet
STEP5 :Install the front pulley bearing retainer SPACER and the front pulley insert by dropping the spacer into the front pulley, while holding the pu
STEP 8 :Install the clutch pack into the rear pulley/clutch basket.The .120” steel plate goes in first, followed by a friction plate, then a steel pla
STEP11 :Using blue threadlock, install the four aluminum stand-offs onto the motor plate assembly. The stand-off with the machinedradius on the bottom
STEP 14 :Install the “INNER” OUTBOARD BEARING SUPPORT PLATEwith the "bearing support shaft" into the front pulley andinstall the bottom-fron
STEP 17 :Carefully install the lower carbon fiber belt guard using the 10/32 x 3/8” bolts & washers provided. Use a drop of bluethreadlock and snu
www.riveraprimoinc.com RIVERA PRIMO Inc. 12450 Whittier Blvd, WHITTIER, CA 90602(562) 907-2600 FAX (562) 907-2606 E-mail: [email protected]
Comments to this Manuals