Rivera-primo Centri-Force - Chain Drive User Manual download pdf

ADDITION TO CENTRI-FORCE

INSTRUCTIONS

for CHAIN DRIVE

APPLICATIONS

1108-0047

The Centri-Force™ with chain drive basket is shipped from our factory ready to install.

Depending on the idle rpm of your engine and individual needs, the way it is setup from

the factory should get you started.

INSTALLATION

Installation of the Centri-Force™ on chain drive applications is easy. First drain and then remove

the outer primary cover. Next remove the compensator nut and the clutch hub nut and the chain

adjuster nut. Remove the complete chain drive assembly. Remove the Centri-Force™ centrifugal

pressure plate by removing the (12) 10-32 x ¾" bolts. (If you remove any clutch plates, they

must be re-installed in the exact same order). Replace the OE clutch basket with your new

Rivera Primo clutch basket assembly minus the Centri-Force™. Re-install the primary drive and

secure the comp assembly, chain adjuster and clutch basket with the proper fasteners tightened

to OE specs. Now re-install the Centri-Force™ with the same (12) 10-32 x ¾" bolts. After you

install the Centri-Force™ clutch, thread the adjuster screw in the center hole.

ADJUSTMENT

CABLE CLUTCH

Turn out the center adjuster screw. Now back off on the clutch cable adjuster until the clutch

lever touches the handlebar grip. Tighten the clutch cable adjuster jam nuts. Hold the clutch

lever against the handle bar and with the other hand, screw in the center adjusting screw until

you feel it push against your hand thru the lever. At this point, lock down the center adjusting

screw jam nut.

Start the bike, making sure the transmission is in neutral. Rev the motor up to around 2000-2500

rpm's, the lever should move out away from the handlebar. At no time should the lever extend

out all the way from the handlebar, you must have free play at the end of the lever travel

just like a normal clutch. At idle and low rpm, there will be very little clutch pull.

IMPORTANT SAFETY

PRECAUTIONS

WARNING: DO NOT START THE MOTORCYCLE

UNLESS THE TRANSMISSION IS IN NEUTRAL

OR THE CLUTCH LEVER IS HELD IN, OR

SERIOUS INJURY MAY OCCUR.

WHILE STOPPED, PUT THE TRANSMISSION IN

NEUTRAL OR HOLD THE CLUTCH LEVER IN.

FAILURE TO FOLLOW THESE PRACTICES MAY

CAUSE SERIOUS INJURY OR SERIOUS

DAMAGE TO THE MOTORCYCLE.

1 2

IMPORTANT SAFETY 1
PRECAUTIONS 1

Summary of Contents

Page 1 - PRECAUTIONS

ADDITION TO CENTRI-FORCETM INSTRUCTIONSfor CHAIN DRIVE APPLICATIONS1108-0047The Centri-Force™ with chain drive basket is shipped from our factory rea

Page 2

12450 Whittier Blvd. Whittier, California 90602 www.riveraprimoinc.com Tel: 562-907-2600 Fax: 562-907-2606 HYDRAULIC CLUTC

Comments to this Manuals

No comments

Rivera-primo Centri-Force - Chain Drive User Manual

Browse online or download User Manual for For the car Rivera-primo Centri-Force - Chain Drive. Rivera Primo Centri-Force - Chain Drive User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for For the car Rivera-primo Centri-Force - Chain Drive